Boiler Replacement: Sizing, Venting and What Changes From the Old Unit
The old boiler was sized for a different building and a different code. Here is what changes when it is replaced.
Size to the load, not the nameplate
Many existing boilers were oversized. A replacement is sized to the building’s actual heating load, which often means a smaller or modulating boiler that runs longer and cycles less.
Condensing or not
Condensing boilers reach high efficiency at low return water temperatures. Whether the building’s loop can run that way decides whether the efficiency is realized.
What else changes
- Venting materials and routing for the new boiler type.
- Gas piping capacity.
- Controls, outdoor reset and integration with the building system.
- Permits, inspections and Title 24 compliance.
How the load is measured
The replacement is sized from the building’s heating load, taking the existing boiler’s run history, the loop design and the building’s use into account. Oversizing is the common mistake; it short-cycles and wears the new boiler early.
Mechanical room changes
- Venting routed and sized for the new boiler type, often through a different material.
- Combustion air provisions checked for the room.
- Gas piping capacity confirmed.
- Pumps, expansion tank and air separation reviewed with the new boiler’s flow needs.
- Controls and outdoor reset integrated with the BAS.
Permits and inspections on a boiler
A boiler replacement is permitted work, and larger boilers may also involve the air district. B&B sequences the building permit, any air-district filing and the inspections with the heating-season schedule so the building is not left cold waiting on paperwork.
Frequently Asked Questions
Can a boiler be replaced during heating season?
Yes, with a planned window and, where needed, temporary heat. Fall is the easier time.
Why not just install the same model?
Codes and the building’s load have changed; the same model may no longer be available or appropriate.
Does a modulating boiler help?
It matches output to load, which reduces cycling and wear.
Can a condensing boiler be installed on an old loop?
Yes, if the loop can run at the return temperatures that let it condense; otherwise the efficiency gain is not realized and a non-condensing unit may be the honest choice.
Should pumps be replaced with the boiler?
If they are near the end or the new boiler needs different flow, yes; it avoids a second outage.
Terms used in this guide
- Boiler Short-Cycling
- Short-cycling is a boiler firing, satisfying its controller within minutes and shutting down, over and over. It is a symptom of an oversized boiler, low loop flow, a controller deadband set too tight or a failing sensor, and it wears igniters and valves quickly.
- CSD-1
- CSD-1 is the ASME standard for controls and safety devices on automatically fired boilers. California references it for commercial boilers, which is why safety trips, low-water cutoffs and flame safeguards on a commercial boiler are tested to it.
- Flame Safeguard
- A flame safeguard is the control that proves a boiler's pilot and main flame are present and shuts the fuel valve if they are not. Lockouts after ignition attempts usually trace to a dirty flame sensor, ignition problem or unstable flame.
- Low Water Cutoff
- The low water cutoff is one of the most important safety devices on a boiler, designed to shut down the burner immediately if the water level drops below a safe threshold. Sludge or scale buildup inside the float chamber or on electronic probes can cause it to stick and fail to read the actual water level.
Next step
Boiler ReplacementAbout this service
Boiler Services →Talk to a real technician.
Tell us what's going on and our San Diego team will reach out. For emergencies, call us 24/7 at (619) 713-0400.
Call us 24/7(619) 713-0400- 24/7 Emergency Service
- Licensed & Insured
- 5.0★ Rated on Google
- Based in Lakeside, CA
10031 Maine Ave, Lakeside, CA 92040
Request your service
No obligation. We never sell your info.
