Skip to main content
B&B Mechanical — commercial HVAC in Lakeside, CA
Hotels & resorts

Hotels & Resorts

A resort cannot close a wing to fix the plant. B&B Mechanical retrofitted the chiller and cooling tower at the Riviera Resort & Spa in Palm Springs, where the cooling load in summer leaves no room for a plant that is not sure of itself.

Guest comfort is the schedule

Hospitality work is phased so guest rooms, kitchens, ballrooms and pools stay in service. Equipment arrives when it can be set and connected in one window, and the plant is brought back on before check-in.

Desert and coastal loads

Palm Springs resorts carry long, hot cooling seasons that load chillers and towers hard; coastal hotels fight salt air on every piece of outdoor equipment. Both need a maintenance plan written for the climate, not a generic checklist.

Scopes we handle

  • Chiller retrofit and service.
  • Cooling tower replacement and repair.
  • Condenser water pumps and VFDs.
  • Boilers for heating and hot water loops.
  • Preventative maintenance across the plant.

Typical scopes for hospitality

  • Chiller retrofit and service for central plants serving guest rooms and public spaces.
  • Cooling tower replacement and repair, including desert and coastal corrosion conditions.
  • Condenser water pumps and VFDs.
  • Boilers for heating and hot water loops that run around the clock.
  • Preventative maintenance written for the property's season and climate.

Phasing work on an operating property

Hospitality projects are phased by area: guest wings, kitchens, ballrooms, spa and pool systems each get their window. Equipment is staged to be set and connected in one shift, temporary cooling bridges any gap, and the plant is back on before check-in. The Riviera Resort & Spa chiller and tower retrofit in Palm Springs ran this way.

Climate-specific maintenance

Palm Springs resorts carry long, hot cooling seasons that load chillers and towers for months; coastal hotels in Coronado, La Jolla and Carlsbad fight salt air on every outdoor component. Maintenance intervals, coil protection and tower inspections are set for the property's climate rather than a generic schedule.

Signs a hospitality plant needs attention

  • Guest rooms on the top floors or the sunny side that will not cool.
  • Ballroom or kitchen areas overheating when full.
  • A chiller logging high head pressure through the afternoon.
  • Tower fan noise audible from the pool deck or guest wings.
  • Hot water that lags in the morning rush.

Readings before peak season beat an emergency during it.

What drives the cost of hospitality plant work

Phasing by area, night and shoulder-season labor, temporary cooling and guest-wing access all appear as their own lines. Equipment selection follows the property's load profile and climate rather than a like-for-like swap, and repair versus retrofit is compared in writing.

Desert and coastal conditions

Palm Springs plants run hot for months and load chillers and towers continuously; coastal properties fight salt air on every outdoor component. Maintenance intervals, coil protection and tower inspections are set to the property's climate. The chiller and cooling tower guides in the Learning Center explain what the readings on your service reports mean.

Frequently asked questions

Do you travel outside San Diego County for resort work?
Yes. The Riviera Resort & Spa project was in Palm Springs; Temecula and Palm Springs are listed service areas.
Can the plant stay on during a chiller retrofit?
Work is phased and, where needed, temporary cooling bridges the changeover so guest areas stay conditioned.
Can plant work happen during peak season?
Emergency work, yes. Planned retrofits are scheduled for shoulder seasons where possible, with temporary equipment where they cannot wait.
Do you service hotel kitchens' make-up air and exhaust?
Yes, as part of the building's mechanical scope; kitchen hood systems themselves are coordinated with the kitchen contractor.
Can you work overnight so guests are not disturbed?
Yes. Noisy or disruptive work is scheduled for the hours the property sets, with equipment staged ahead of time.
Do you maintain pool and spa heating equipment?
Boilers and heat exchangers serving pools and spas are part of the property's mechanical scope; pool chemistry and filtration are the pool contractor's.
Buildings we serve

Need commercial mechanical help for hotels & resorts?

Tell us what's going on and our San Diego team will reach out. For emergencies, call us 24/7 at (619) 713-0400.

Call us 24/7(619) 713-0400
  • 24/7 Emergency Service
  • Licensed & Insured
  • 5.0★ Rated on Google
  • Based in Lakeside, CA

10031 Maine Ave, Lakeside, CA 92040

Request a quote

Request your service

No obligation. We never sell your info.

Request Service

Tell us what's going on and our San Diego team will reach out. For emergencies, call us 24/7 at (619) 713-0400.

Loading form. If it does not load, please use the other contact options on this page.

By submitting, you agree to our Privacy Policy and Terms & Conditions. If you opt in to texts, message & data rates may apply and you can reply STOP to opt out.

Call Now Request Service